Eaton EMR-3MP0 - Programmable Logic at the Panel; How to configure a logic equation?

LogicMain_E06
Output of Logic Equation 1
LE2 . IN1
LE2 . IN2
LE2 . IN3
LE2 . IN4
Logic Equation2
LE1 . IN2
LE1 . IN3
LE1 . IN4
Logic Equation1
Update within the same evaluation cycle
Update within the next evaluation cycle (1 cycle delay)
Output of Logic Equation 2
Fig. 55: Cascading in Descending Order
LogicMain_E07
LE3 . IN1
LE3 . IN2
LE3 . IN3
LE3 . IN4
Logic Equation3
LE2 . IN2
LE2 . IN3
LE2 . IN4
Logic Equation2
Output of Logic Equation 1
LE1 . IN2
LE1 . IN3
LE1 . IN4
Logic Equation1
Update within the same evaluation cycle
Update within the next evaluation cycle (1 cycle delay)
Update within the next but one evaluation cycle (2 cycles delay)
Output of Logic Equation 3
Output of Logic Equation 2
Fig. 56: Cascading in Descending Order
Programmable Logic at the Panel
WARNING!
Improper use of logic equations might result in personal injury or damage the electrical
equipment. Do not use logic equations unless the user can ensure the safe functionality.
How to con󰅡gure a logic equation?
• Within the Device Planning, set the number of required Logic Equations.
• Enter the [Logic] menu.
216 www.eaton.com EMR-3MP0
6 Programmable Logic