Eaton EMR-3MP0 - Page 217

• Select a Logic Equation that is to be set.
• Set the Input Signals (where necessary, invert them).
• If required, con󰊎gure the timers (»LEx.t-On Delay« and »LEx.t-O󰅠 Delay«).
• If the latched output signal is used, assign a reset signal to the reset input.
• Within the »status display«, the user can check the status of the logical inputs and
outputs of the logic equation.
In case the logic equations should be cascaded, the User has to be aware of timing delays
(cycles) in case of descending sequences (Please refer to the Cascading Logical Outputs
section).
By means of the Status Display [Operation / Status Display], the logical states can be
veri󰊎ed.
217www.eaton.comEMR-3MP0
6 Programmable Logic