C-60 IM02601001E www.eaton.com
Modbus Register Maps
7D59 - 7F3E 32090 - 32575 Reserved Set to 0. 486
Block Size: 512
Programmable Settings for Option Card 2
Option Card 2 Setups Block write only in PS update
mode
80E7
-
80E7 33000
-
33000 Class ID of the Option Card 2 Settings UINT16 bit-mapped -------- cccctttt Which class (cccc) and
type(tttt) of card the Op-
tion Settings for Card 2
apply to. See note 19.
1
80E8 - 8126 33001 - 33063 Settings for Option Card 2, First Overlay
-- see below
Register assignments depend on which type of card is in the slot. See overlays below. 63
8127 - 8326 33064 - 33575 Settings for Option Card 2, Second Overlay
-- see below
Register assignments depend on which type of card is in the slot. See overlays below. 512
Block Size: 576
Overlays for Option Card 2 Programmable Settings
Settings Registers for any communication capable card, including analog cards First Overlay write only in PS update
mode
80E8 - 80E8 33001 - 33001 Slave address UINT16 1~247 (for Modbus)
1~65534 (for DNP)
none Slave address of the
unit. The communica-
tion capable card is
always a master.
Set to 0 when an analog
board is installed.
1
80E9 - 80E9 33002 - 33002 Speed and format UINT16 bit-mapped -abcde--fghijklm Bps: a=57600; b=38400;
c=19200; d=14400;
e=9600
Stop bits 'f': cleared 1
stop bit, set 2 stop bits
Parity: g=even; h=odd;
i=none
Data bits: j=8; k=7; l=6;
m=5
Set to 0 when an analog
board is installed.
1
80EA - 80EA 33003 - 33003 Reserved UINT16 bit-mapped Set to 0. 1
80EB - 80EB 33004 - 33004 Protocol UINT16 bit-mapped -------- -----ppp- ppp= 100 =DNP3 Lite;
010=Ascii Modbus;
001=Rtu Modbus
Set to 0 when an analog
board is installed.
1
80EC - 80EC 33005 - 33005 Reply delay UINT16 0 to 65535 milliseconds Delay to reply to a
Modbus transaction
after receiving it.
Set to 0 when an analog
board is installed
1
80ED - 8126 33006 - 33063 Reserved
Set to 0. 58
Block Size: 63
To Next Page
Loading...
