www.eaton.com IM02601001E C-61
Modbus Register Maps
Settings Registers for Digital I/O Relay Card First Overlay write only in PS update
mode
80E8 - 80E8 33001 - 33001 Input#1 - 2 bindings & logging enables UINT16 bit-mapped -------- 2222 1111 One nibble for each
input.
Assuming "abcd" as the
bits in each nibble:
"a": select this input
for EOI (End Of Interval)
pulse sensing.
"b": log this input when
pulse is detected
"cc": Input event trigger
mode - Contact sensing
method; 00 = none; 01
= open to close; 10 =
close to open; 11 = any
change.
1
80E9 - 80E9 33002 - 33002 Relay #1 Delay to Operate UINT16 0.1 second units
Delay to operate the
relay since request.
1
80EA - 80EA 33003 - 33003 Relay #1 Delay to Release UINT16 0.1 second units
Delay to release the
relay since request.
1
80EB - 80F0 33004 - 33009 Reserved UINT16
Set to 0. 6
80F1 - 80F1 33010 - 33010 Relay #2 Delay to Operate UINT16 0.1 second units
Delay to operate the
relay since request.
1
80F2 - 80F2 33011 - 33011 Relay #2 Delay to Release UINT16 0.1 second units
Delay to release the
relay since request.
1
80F3 - 8108 33012 - 33033 Reserved UINT16
Set to 0. 22
8109 - 8109 33034 - 33034 Input Accumulators Scaling UINT16 bit-mapped -------- 22221111 * 4 bits per accumulator
* 0xF disables the ac-
cumulation
* 0-5 = power of
divisor for the scaled
accumulator
Example: count=12456,
4bits=3:
divisor=103=1000 &
scaled accumulator=12.
1
810A - 810A 33035 - 33035 Relay Accumulators Scaling UINT16 bit-mapped -------- 22221111 1
810B - 8126 33036 - 33063 Reserved
Set to 0. 28
Block Size: 63
Settings Registers for Digital I/O Pulse Output Card First Overlay write only in PS update
mode
80E8 - 80E8 33001 - 33001 Input#1 - 4 bindings & logging enables UINT16 bit-mapped 44443333 22221111 One nibble for each of
the 4 inputs.
Assuming "-bcc" as the
bits in each nibble:
"b": Log this input when
pulse is detected
"cc": Input event trigger
mode - Contact sensing
method; 00 = none; 01
= open to close; 10 =
close to open; 11 = any
change.
1
To Next Page
Loading...
