Eaton PowerXL DC1 Series - Modbus Parameters

8 Modbus RTU
8.2 Modbus parameters
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com 137
8.2 Modbus parameters
Table 14 below shows the Modbus parameters in DC1 variable frequency
drives.
RUN Indicates the access right during operation (FWD or REV)
- = No parameter change possible,
/ = Parameter change possible.
ro/rw Indicates the access right via the field bus
ro = Read only possible,
rw = Read and write possible.
￫
P-36 – Timeout
Parameter P-36 indicates the time after which there will be a
response to a loss of communications.
If P-36 = 0, the function will be disabled.
"t" at the beginning means: error message and coasting
"r" at the beginning means: stop with second braking ramp time