Eaton PowerXL DC1 Series - DX-Key-Led

11 Annex
11.7 External keypad
190 DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com
Button combinations for external keypads
11.7.2 DX-KEY-LED
The external DX-KEY-LED 7-segment LED keypad has the same functions as
the internal keypad.
Figure 101: DX-KEY-LED
Setting the keypad port
To set the keypad port, use the OK + Stop +  button combination. After
you use the combination, the display will show "Port-1."
Use the arrow keys to set the port you want (Port-1 or Port-2).
Pressing the OK + Stop +  button combination again will save the keypad
port setting you just configured.
Setting the variable frequency drive address
To set the variable frequency drive address, use the Stop +  button combi-
nation. After you use the combination, the display will show "Adr-01."
Use the arrow keys to set the variable frequency drive address you want
(Adr-01, Adr-02 to Adr-63).
Pressing the Stop + ▼ button combination again will save the address and
load the data from the variable frequency drive.
Function Key combination
Keypad Port
Variable frequency drive
address
Language
1)
1) On DX-KEY-OLED keypads only