3 Installation
3.2 Mounting
42 DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com
3.2.1 Mounting position
DC1 series variable frequency drives are designed to be mounted vertically.
The maximum permissible inclination is 30°.
Figure 17: Mounting position
3.2.2 Free space
To ensure that there is sufficient air circulation, appropriate thermal clear-
ances must be maintained, with these clearances depending on the size of
the specific variable frequency drive.
Figure 18: Clearances for air cooling (left: IP20; right: IP66)
￫
The variable frequency drives can be mounted side by side
without any lateral clearance between them.
b
c
a
c
a
1234567891011 1234567891011
c
a
c
REV FWD
0
ON
OFF
PWR
b
a
To Next Page
Loading...
