11 Annex
11.10 Expansion modules
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com 197
11.9.4 drivesConnect
The drivesConnect parameter configuration program can be used with a
computer in order to quickly configure a DC1 variable frequency drive's
parameters, as well as to control, diagnose, document (by printing and saving
the corresponding parameter lists), and transfer data from and to the variable
frequency drive.
The drivesConnect program is found in the CD enclosed with the variable
frequency drive and can also be downloaded for free on the Internet.
To be able to use the function block editor's full functionality, you will need a
license for it. A DX-COM-SOFT dongle is required for this purpose.
In order to establish a connection to the computer, you will need
a DX-COM-STICK or the connection cable included with the DX-COM-PC-KIT
or DX-CBL-PC-1M5.
11.10 Expansion modules
11.10.1 DXC-EXT-IO110, DXC-EXT-IO230
Figure 109: DXC-EXT-IO110 and DXC-EXT-IO230
The DXC-EXT-IO110 and DXC-EXT-IO230 expansion modules can be used to
integrate the digital inputs on DC1 variable frequency drives directly into
circuits with 110 VAC / 230 VAC. These inputs are galvanically isolated from
the variable frequency drive.
￫
For more information on drivesConnect and the various
computer connection options, please refer to manual
MN040003EN, "drivesConnect · Parameter Configuration
Software for PowerXL™ Variable Frequency Drives."
1 2 3 4 5 6 7 8 9 10 11
To Next Page
Loading...
