Eaton PowerXL DC1 Series - DX-Key-Oled

11 Annex
11.7 External keypad
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com 191
11.7.3 DX-KEY-OLED
The DX-KEY-OLED external keypad with an organic LED display has a display
that shows plaintext messages in a variety of languages. DX-KEY-OLED
external keypads have two additional buttons: Hand and Auto. These
buttons do not serve any purpose when used with DC1 variable frequency
drives.
Figure 102: DX-KEY-OLED
Setting the keypad port
To set the keypad port, use the OK + Stop +  button combination. After
you use the combination, the display will show "01."
Use the arrow keys to set the port you want (01 or 02).
Pressing the Stop button again will save the port setting you just configured.
Setting the variable frequency drive address
To set the variable frequency drive address, use the Stop +  button combi-
nation. After you use the combination, the display will show "01."
Use the arrow keys to set the variable frequency drive address you want
(01, 02 to 63).
Pressing the Stop button will save the address.
Setting a language
To set a display language, use the Start +
 button combination. After you
use the combination, the display will show "Select Language." Use the
arrow keys to switch to the language you want. Pressing the OK button will
save the language setting you select.
Hand Auto