113
© 2017 Eaton. All rights reserved
2019.07.11
MHP/MXP/VHP/VXP Auxiliary Countershaft Installation | Service Procedures TRSM0940
7. Place the Auxiliary Housing over the Countershaft
Assemblies and the Auxiliary Mainshaft Assembly.
8. Ensure the rear
Auxiliary Mainshaft bearing spacer is
installed on the shaft.
9. Heat the Rear Auxili
ary Mainshaft Bearing cone and
install the bearing, tapered side down, on the shaft.
10. Position
a new gasket on the Rear Bearing Cover, and
install the cover.
To Next Page
Loading...