155
© 2017 Eaton. All rights reserved
2018.12.12
Oil Pump and Lube Tube Installation | Service Procedures TRSM0940
11. Install the rear lower Counter Shaft Bearing snap ring.
12. Using the bearing driver RR10
12TR-2, install the front
lower Counter Shaft Bearing onto the Counter Shaft
and into the bore of the Transmission Main Case.
Note: Using an old race for the
front Counter Shaft
Bearings helps keep the rollers in place during
installation.
13. In
stall the front lower Counter Shaft Bearing retaining
washer and bolt and torque to 90–120 lb-ft.
To Next Page
Loading...
Need help?
General
