2018.12.12
© 2017 Eaton. All rights reserved
64
TRSM0940 Service Procedures | VCS/VMS Auxiliary Section Assembly and Installation
4. Install the Range and Deep Reduction Yokes into their
respective sliding clutches on the Auxiliary Mainshaft.
5. On th
e Deep Reduction Yoke, install the O-ring the will
seat against the piston, P/N 4301348.
6. Lay the Auxiliary Case Housing
front on a clean flat
surface. Install the Bearing Race in the Bearing Bore.
7. Position the
Auxiliary Case Housing over the Counter-
shaft and Auxiliary Mainshaft Assemblies.
Note: Ensure the inner
spacer is installed on the Auxil-
iary Mainshaft.
8. In
stall the rear Auxiliary Mainshaft bearing with the
tampered side forward. Use heat or a bearing driver to
fully seat the bearing.
9. Position a new Output
Bearing Cover gasket on the rear
Output Bearing Cover mounting surface and install the
Rear Bearing Cover
10. Apply Eaton® sealant #71205
or equivalent to the
retaining cap screws.
To Next Page
Loading...