Further markings
The following markings are used in this manual to highlight operating instructions, results,
collections, references and other elements:
Marking Explanation
1., 2., 3. ...
Step by step operating instructions
ð
Results of the operating steps
References to sections of this manual and related documents
Collections in no set order
[Button] Controls (e.g. button, switch), indicators (e.g. signal lights)
‘Display’ Screen elements (e.g. buttons, assignment of function keys)
1.1.2 EBS article numbers
Both item numbers and EBS numbers may be given in these operating instructions.
EBS numbers are Ecolab-internal item numbers and are used exclusively “within the
group”.
1.2 Shipping, packaging and storage
1.2.1
Shipping
The unit is delivered in suitably adapted packaging. The dimensions of the packaging and
packing weight please refer to the "Technical Data" chapter .
Improper transport
NOTICE!
Material damage due to improper transportation!
Transport units can fall or tip over if improperly transported. This can cause a
high degree of damage.
– Be careful when unloading the transport units on delivery and during
inhouse transport; observe the symbols and instructions on the packaging.
–
Only use the attachment points provided.
– Remove packaging just before assembly.
DANGER!
Danger of commissioning a damaged component by the transport device
If transport damage is detected when unpacking the system or system
components, you must not install or commission any part of the system.
According to installation / comissioning of an damaged component
uncontrollable
error may occur because of the use of aggressive metering
there can be irreparable damage to personnel and / or equipment.
General information
6Rev. 1-06.2018
To Next Page
Loading...
Need help?
General