VTEC
VTEC control parameters are used for controlling variable timing and lift of the valves using on/off
type solenoid. There is an option to automatic switch tables when the solenoid state changes. To
do this in parameters Tables Switch/Table switch mode option VTEC Switch must be enabled.
Activation of VTEC control solenoid can be defined by two non-continuous areas, in ranges of
RPM, TPS and intake manifold pressure (MAP).
PARAMETER DESCRIPTION
VTEC Output The EMU output used for VTEC control solenoid
Invert output Inverting the output state
RPM Min/Max The range of RPM that is used for activation of VTEC control solenoid
RPM Hist. RPM range hysteresis
MAP Min/Max
The range of MAP sensor values that is used for activation of VTEC
control solenoid
MAP Hist MAP range hysteresis
TPS Min / Max
The range of throttle position that is used for activation of VTEC
control solenoid
TPS Hist TPS range hysteresis
VSS Min The minimum vehicle speed for activation of VTEC control solenoid
VSS Hist Speed hysteresis
Page 108
To Next Page
Loading...