Dyno
Dyno parameters are used to set up road dyno parameters (Dyno). The accuracy of the generated
power curve will largely depend on the preciseness of the values entered.
PARAMETER DESCRIPTION
Coefficient of drag
Coefficient of drag can be found in technical documentation of the car
as a Cx value
Frontal area The frontal area of the car
Car mass The weight of the car (with driver, fuel, etc.)
RPM Ratio
Ratio between RPM and vehicle speed in km/h multiplied by 100
RPMratio = (Speed / RPM) * 100
Filter power
The coefficient of digital filter used to smooth power and torque curve.
The higher value the more filtering will be applied
Aero correction
If this parameter is checked the aerodynamics of the car (parameters
Coefficient of drag and Frontal area) are used for power and torque
calculations
Show AFR Shows AFR curve on the dyno graph
Show MAP Shows MAP curve on the dyno graph
Show IAT Shows IAT curve on the dyno graph
Min RPM Minimal RPM on the dyno graph
Max RPM Maximal RPM on the dyno graph
Page 120
To Next Page
Loading...