Engine protection
Engine protection strategy is used to protect the engine by limiting the maximum RPM when the
specific conditions are met.
PARAMETER DESCRIPTION
Enable over temp. rev limit
Over-temperature engine protection. When CLT temperature is
higher than defined the new rev limit is used
High temperature limit Temperature limit to activate protection function
Rev. limiter
Fuel cut based rev limiter when the temperature is above the
limit
Soft rev. limiter
Soft rev limiter (spark cut based) when the temperature is
above the limit
Enable low temp. rev limit
Cold engine protection. When CLT temperature is lower than
defined the new rev limit is used
Low temperature limit Temperature limit to activate protection function
Rev. limiter Fuel cut based rev limiter when the temperature is below the
limit
Soft rev. limiter Soft rev limiter (spark cut based) when the temperature is below
the limit
Debug functions
Debug functions parameters are used to analyze PID controllers. To analyst a particular PID
controller PID debug option must be selected in options. The controller data is then available for
analysis in the following log channels: Debug PID P Term, Debug PID I Term, Debug PID D Term.
PARAMETER DESCRIPTION
PID Debug option PID controller to be analyzed
Page 119
To Next Page
Loading...