ECUMASTER Serial Protocol - ECUMASTER serial protocol allows
to connect Android based dashboard application.
CAN-Bus - this device type should be selected for CAN-BUS module
support
Always reset EMU device after selecting new device protocol!
CAN-Bus speed Speed of the CAN-BUS
Send EMU data over
CAN-Bus
This option allows to send ECUMASTER EMU data over CAN-BUS
CAN-Bus Dashboard Select supported Dashboard to send compatible data over CAN-BUS
DASHBOARD SUPPORTED FUNCTIONS
BMW E46
RPM, CLT, check engine light, Drive by wire error, overheat light, oil
temperature, alternator light
BMW E46 M3
RPM, CLT, check engine light, Drive by wire error, overheat light,
shift light (limit must be set in Shift Light EMU options), oil
Temperature, alternator light
CITROEN C2 RPM, vehicle speed, enable power steering, enable heater blower
VOLKSWAGEN RPM
FORD FIESTA MK7
RPM, vehicle speed, check engine light, low oil pressure light,
alternator light, overheat light, enable power steering, enable heater
blower
LOTUS
RPM, water temperature, vehicle speed, check engine light, low oil
pressure light, shift light (limit must be set in Shift Light EMU options),
fuel level
MOTEC M800 set 1
RPM, TPS, MAP, IAT, CLT, lambda 1, fuel temp., fuel pressure, oil
temp., oil pressure, EGT 1, EGT 2, VBAT, ECU temp., vehicle speed
HALTECH E8 E11v2 RPM, VSS, oil temp., oil pressure, fuel pressure, VBAT, TPS, MAP,
IAT, EGT1, lambda, ign. angle, gear, injectors DC
PECTEL SQ 6 RPM, VSS, oil temp., oil pressure, fuel pressure, VBAT, TPS, MAP,
IAT, EGT1, EGT2, lambda, ign. angle, gear, injectors DC, ECU Temp
BMW Z4 RPM, Oil pressure light, Oil temperature or CLT if the oil temp. sensor
is not connected, alternator light, Check engine light
MAZDA RX8 RPM, vehicle speed, check engine light, CLT, Oil pressure light,
alternator light
Page 123
To Next Page
Loading...