Chapter 24
| Multicast Filtering Commands
MVR for IPv4
– 704 –
Command Mode
Global Configuration
Command Usage
â—† When MVR proxy-switching is enabled, an MVR source port serves as the
upstream or host interface. The source port performs only the host portion of
MVR by sending summarized membership reports, and automatically disables
MVR router functions.
â—† Receiver ports are known as downstream or router interfaces. These interfaces
perform the standard MVR router functions by maintaining a database of all
MVR subscriptions on the downstream interface. Receiver ports must therefore
be configured on all downstream interfaces which require MVR proxy service.
â—† When the source port receives report and leave messages, it only forwards
them to other source ports.
â—† When receiver ports receive any query messages, they are dropped.
â—† When changes occurring in the downstream MVR groups are learned by the
receiver ports through report and leave messages, an MVR state change report
is created and sent to the upstream source port, which in turn forwards this
information upstream.
â—† When MVR proxy switching is disabled:
â–
Any membership reports received from receiver/source ports are
forwarded to all source ports.
â–
When a source port receives a query message, it will be forwarded to all
downstream receiver ports.
â–
When a receiver port receives a query message, it will be dropped.
Example
The following example enable MVR proxy switching.
Console(config)#mvr proxy-switching
Console(config)#
Related Commands
mvr robustness-value (705)
To Next Page
Loading...
Need help?
General