To Next Page

To Previous Page

A-2

4200 SIDE SCAN SONAR SYSTEM USER HARDWARE MANUAL 0004842_REV_N

7. From the Basic Setup page, click Write Settings to Flash to permanently save the modem settings.

8. Open a telnet session to http://192.9.0.22.

9. Login with username = admin and password = zoomadsl.

10. Enter the following sequence of commands. Wait for a “Set Done” response between commands.

$modify dsl config autosensegdmtfirst Response: "Set Done"

$modify dsl config bitswap enable Response: "Set Done"

$commit Response: "Set Done"

$get dsl config Response: config listing

$exit Response: none, telnet disconnects

The captured telnet session is the following:

$modify dsl config autosensegdmtfirst

Set Done

$modify dsl config bitswap enable

Set Done

$commit

Set Done

$get dsl config

Whip .............. : Disable .............. Annex Type .......... : Annex A

Standard .......... : Autosense GDMT first . Trellis coding ...... : Enable

ExpExchSeq ........ : Expanded ............. Framing structure ... : Framing-3

TxAttenuation(dB) . : 0 .................... Coding Gain ......... : Auto

TxBinAdjust ....... : Enable ............... RxBinAdjust ......... : Disable

TxStartBin ........ : 6 .................... TxEndBin ............ : 31

RxStartBin ........ : 32 ................... RxEndBin ............ : 255

Fast Retrain ...... : Disable .............. Esc Fast Retrain .... : Disable

MaxBits/bin On Rx . : 14 ................... Bit Swap ............ : Enable

Dual Latency ...... : Enable ............... Pmode ............... : Enable

Pilot Request ..... : Enable ............... Last Failed Status .. : 0x0

Oper Status ....... : Showtime/Data ........ Startup Progress .... : 0xad

AC Mode item ...... : dbm .................. AC Ttr R Offset ..... : 42

AC Pilot Request .. : Disable .............. EC Fdm Mode ......... : FDM

Max Down Rate ..... : 0xff

$exit

A.1.2 Zoom ADSL X3 Modem Model 5560 Setup

To set up the Zoom ADSL X3 Modem Model 5560:

1. Open your web browser and enter http://10.0.0.2 or http://192.9.0.22 to connect to the modem.

2. Login with username = admin and password = zoomadsl.

3. From the Basic Setup page, choose the MANUALLY option to configure the modem.

Edgetech 4200 User Manual

Questions and Answers: