Edgetech 4200 - Figure 5-6: Pulling out the Nylon Retaining Line; Figure 5-7: Attaching the End Cap Removal Handle

5-5
7. Using the Phillips screwdriver, remove the finish washer from the side of the housing.
Figure 5-6: Pulling out the Nylon Retaining Line
8. Using the needle-nosed pliers, grip the nylon retaining line and pull it completely out of the
housing (it is sometimes necessary to push on the end cap to remove the nylon line, and using the
supplied handle helps facilitate this).
Figure 5-7: Attaching the End Cap Removal Handle
Nylon
retaining
line
Needle
nosed
pliers
End cap
removal
handle