Edgetech 4200 - Zoom ADSL X5 Modem Model 5564 Setup

A-3
4. From the Advanced Setup page, click ADSL Configuration, make the following ADSL configuration
changes, and then click Save Changes:
Bit Swapping = Enabled
5. From the Advanced Setup page, click WAN Settings, make the following WAN configuration
changes, and then click Save Changes:
Encapsulation = 1483 Bridged IP LLC
Bridge = Enabled
6. From the Advanced Setup page, click LAN, make the following LAN configuration changes, and
then click Save Changes:
IP Address = 192.9.0.22
Subnet Mask = 255.255.255.0
7. From the Advanced Setup page, click Misc. Configuration, make the following miscellaneous
configuration changes, and then click Save Changes:
Command Line Interface = Enabled
8. Wait 60 seconds. The browser will reconnect to the modem.
During the reboot process, the modem LINK LED turns off, and after a successful reboot, it starts
flashing again. If it does not, open a web page to http://192.9.0.22 and log in as user = admin,
password = zoomadsl. Verify that the login succeeds and that the Basic Setup page is displayed,
then close your web browser.
9. Verify that the settings have been saved, and then close the web window.
A.1.3 Zoom ADSL X5 Modem Model 5564 Setup
To set up the Zoom ADSL X5 Modem Model 5564:
1. Open your web browser and enter http://10.0.0.2 or http://192.9.0.22 to connect to the modem.
2. Login with username = admin and password = zoomadsl.
3. From the Basic Setup page, choose the MANUALLY option to configure the modem.
4. From the Advanced Setup page, click WAN Settings, make the following WAN configuration
changes, and then click Save Changes:
Encapsulation = 1483 Bridged IP LLC
VPI = 0
VCI = 35
Bridge = Enabled
5. From the Advanced Setup page, click LAN Settings, make the following LAN configuration changes,
and then click Save Changes: