3-3
3.2.2 Changing to a Non-US Power Plug
An AC power cord is provided for connecting the Deck Unit to a standard U.S. 3-pronged outlet. For non-
U.S. power outlets, users can modify this cord by cutting off the 3-pronged plug and attaching the
appropriate plug. Refer to T
ABLE 3-1 for connection information.
AC POWER CORD WIRE COLOR
FUNCTION
Black AC line
White AC neutral
Green Earth ground
Table 3-1: AC Power Cord Wiring
3.3 Navigation Interface
The 4200 Series High Definition Dual-frequency Side Scan Sonar System accepts all standard National
Marine Electronics Association (NEMA) 0183 message sentence formats from a connected global
positioning system (GPS) or integrated navigation system.
3.4 Topside Processor Placement
The 4200 Rack Mount Topside Processor and the 701-DL Digital Link should be located and set up in a dry,
sheltered area that is protected from weather and water spray. Both of these units also require an
environment where the temperature is consistently between 0 and 45°C (32 and 113°F) The 4200-P
Portable Topside Processor can be located in a wet environment if the cover is kept closed.
In all cases, however, avoid areas of direct sunlight, especially in tropical environments, as heat buildup
could damage the equipment, and glare could hinder the user's ability to see LCDs and status indicators.
The location of the processor should also allow users to communicate directly with the deck crew that is
handling the tow vehicle.
Secure the topside processor in place, using tie-downs if necessary, near the required AC power source.
When mounting a 4200 Rack Mount Topside Processor or 701-DL Digital Link in a 19-inch rack, ensure that
there is ample room behind the rack for connecting the cables. Support the components inside the rack
using appropriate mounting brackets and secure the front panels using standard 19-inch rack front panel
mounting hardware.
To Next Page
Loading...
