A-4
4200 SIDE SCAN SONAR SYSTEM USER HARDWARE MANUAL 0004842_REV_N
Conf. LAN IP Address = 192.9.0.22
Conf. LAN Network Mask = 255.255.255.0
6. Open a web page to http://192.9.0.22 and log in as user = admin,
password = zoomadsl
7. From the Basic Setup page, click Write Settings to Flash to permanently save the modem settings.
8. Wait 60 seconds. The browser will reconnect to the modem.
During the reboot process, the Modem LINK LED turns off, and after a successful reboot, it starts
flashing again. If it does not, open a web page to http://192.9.0.22 and log in as user = admin,
password = zoomadsl. Verify that the login succeeds and that the Basic Setup page is displayed,
then close your web browser.
9. Verify that the settings have been saved, and then close the web window.
10. Open a telnet session to http://192.9.0.22.
11. Login with username = admin and password = zoomadsl.
12. Enter the following sequence of commands, wait for a “Set Done” response between commands.
$modify dsl config defaultsgdmt Response: "Set Done"
$modify dsl config bitswap enable Response: "Set Done"
$commit Response: "Set Done"
$get dsl config Response: config listing
$exit Response: none, telnet disconnects
The captured telnet session is the following:
$modify dsl config defaultsgdmt
Set Done
$modify dsl config bitswap enable
Set Done
$commit
Set Done
$get dsl config
Whip ............... : Disable ............. Irellis coding ...... : Disable
Conn Standard ...... : - ................... Max Down Rate ....... : 0xff
ExpExchSeq ......... : Expanded ............ Framing structure ... : Framing-3
TxAttenuation<dB> .. : 0 ................... Coding Gain ......... : Auto
TxBinAdjust ........ : Disable ............. RxBinAdjust ......... : Disable
TxStartBin ......... : 6 ................... TxEndBin ............ : 31
RxStartBin ......... : 32 .................. RxEndBin ............ : 255
Fast Retrain ....... : Enable .............. Esc Fast Retrain .... : Disable
MaxBits/bin On Rx .. : 15 .................. Bit Swap ............ : Enable
Dual Latency ....... : Disable ............. Pmode ............... : Enable
Pilot Request ...... : Enable .............. Last Failed Status .. : 0x0
To Next Page
Loading...
Need help?
General
