Edgetech 4200 User Manual

A-7
6. Do one of the following:
• If an IP Address = 10.0.0.2 is listed, the subnet for 10.0.0.x already exists, but the IP Address
conflicts with that of the modem. Change the IP Address by selecting it and clicking Edit to
open it in the TCP/IP Address window, and then edit the IP Address in the TCP/IP Address
window by entering
IP Address = 10.0.0.99
Subnet Mask = 255.255.255.0
and then clicking OK until done.
• If another IP Address in the range 10.0.0.x is listed, the subnet for 10.0.0.x already exists,
and no further action is required to add the subnet. Skip the remaining steps in this section
by clicking Cancel until done.
• If no IP Address in the range 10.0.0.x is listed, click Add to open the TCP/IP Address window,
then add the new subnet in the TCP/IP Address window by entering
IP Address = 10.0.0.99
Subnet Mask = 255.255.255.0
and then clicking Add followed by clicking OK until done.

Edgetech 4200 Specifications

General

Brand	Edgetech
Model	4200
Category	Sonar
Language	English