22 TP-00347-01
Chapter 2: Installation
Installing the Library
Tools Required
The following tools are required to install the library:
•No. 3 Phillips screwdriver
• T10 Torx screwdriver
Rack-Mounting the Library
To rack mount the library:
1. Determine the location in which the library rack is to be installed.
2. Use a pencil to mark the location on each vertical rail in the rack.
3. In the rack mount kit are two sets of eight M6 sc
rews. Determine the type of rack then
choose the appropriate type of M6 screws.
4. Secure one rail to each side of the rack in your chosen rack location with a #3 Phillips
screwdriver. I
nsure the rails are mounted level and at the same rack height on each
side.
5. Secure both the front and back of each
rack rail to the rack.
To Next Page
Loading...