TP-00347-01 75
Servicing a Magazine
Servicing a Magazine
To remove a magazine:
1. Unlock the appropriate magazine, using:
• "Operator Control Panel (OCP)" on page 33
• "Remote Management Unit (RMU)" on page 44
• "Emergency Release" on page 84 - Use this method if you are unable
to unlock the
magazine with the OCP or RMU
2. Pull the released magazine out of the library.
3. Remove all tape cartridges from the magazine.
4. To store or ship the removed magazine, repackage it
in the replacement device packaging
materials.
5. Insert an appropriate magazine into the empty magazine slot of
the library.
6. Slide the magazine completely into the library. The magazine locks into place once it is
correctly installed.
Base Chassis
Preparing to Remove the Base Chassis
The Base Chassis is heavy, observe the Safety Procedures described in page 3.
1. If the OCP or RMU is working:
• Write down the system, drive, and network configuration settings. You will need these
settings to re-configure the library after replacing the base chassis.
• Remove all tape cartridges to reduce the weight, see "Removing Tape Cartridges from
Tape Library" on page 83
• Remove the magazines from the libr
ary, using the OCP or RMU.
2. If the OCP or RMU does not work, remove the magazines manually. See "Emergency Release"
on page 84.
3. Power down the library by pressing the
power button on the front panel.
4. Remove the cables from the rear panel of the library.
5. Remove the power supply - see "Removing a Power Supply" on page 74
6. Remove the tape drive(s) - see "Removing a Tape Drive" on page 72.
7. Remove the library controller - see "Removing a Library Controller" on page 73.
To Next Page
Loading...