44 TP-00347-01
Chapter 4: Operation
Remote Management Unit (RMU)
Overview
Many of the same operations performed locally from the operator control panel (OCP) can also be
performed remotely using the network connected Remote Management Unit (RMU).
The RMU lets you monitor and control the library from any computer connected to your network
or
through the World Wide Web (WWW). The RMU hosts a dedicated, protected Internet site that
displays a graphical representation of the library.
After establishing a network connection to the libr
ary, open any HTML browser and enter the IP
address of the library. To allow access from the RMU, you must first set the desired static IP address
at the OCP or configure to use DHCP.
Operation Modes
The following operations are available through the remote management unit as explained below:
1) Identity
• Viewing the static library identity
• Viewing the static drive identity
• Viewing the network identity
2) Status
• Viewing the dynamic library status
• Viewing the dynamic drive status
• Viewing the tape cartridge inventory
3) Configuration
• Changing the system configuration
• Changing the logical library configuration
• Setting the license key
• Changing the drive configuration
• Changing the network configuration
• Changing the SNMP configuration
• Changing the user password
• Setting date/time
• Setting error log mode
• Setting event for email no
tification parameters
• Restoring factory defaults
4) Operations
• Move media within the library
• Rescanning the media inventory
To Next Page
Loading...