TP-00347-01 71
Chapter 5: Servicing
Static Sensitive Devices are used in this Equipment.
Always observe the procedures for handli
ng these devices as described in
"Warnings and Cautions" on page 3.
This chapter describes the procedures for servicing the tape librar
ies. See the following sections:
• "Tools Required" on page 71
• "Storing and Shipping Components" on page 71
• "Tape Drives" on page 72
• "Library Controller" on page 73
• "Power Supplies" on page 74
• "Servicing a Magazine" on page 75
• "Base Chassis" on page 75
• "Packaging the Unit for Transportation" on page 76
Tools Required
The following tools are required to service the tape library:
•No. 2 and No. 3 Phillips Screwdrivers
• Flat Blade Screwdrivers - Large and Small
•Ground Strap
Storing and Shipping Components
When storing or shipping components such as tape drives, library controllers and power supplies,
always repackage them in the original or replacement device packaging materials.
To Next Page
Loading...