48
6.4
Generator Charge Settings
• Batt Charge Current Limitation (A): Battery charge current limitation from Generator.
•
Gen Rated Power (kW): You can limit the battery charge power based on the detected LOAD con-
sumption and Generator input power limitations.
•
Charge Starts Volt(V)/SOC(%): While using auto-start function of the generator, you can limit the
charge start voltage / SOC to start up the generator automatically.
•
Charge End Volt(V)/SOC(%): While using auto-start function of the generator, you can limit the
charge end voltage / SOC to turn off the generator automatically.
6.5
Discharge Settings
• Batt Discharge Control: If the inverter communicates with the Lithium battery and is capable of
closed-loop communication, then you can select charge control according to “SOC.” When using lead-
acid batteries or lithium batteries without communication, you can always select charge control ac-
cording to “VOLT.”
•
On-Grid Discharge Cut-Off SOC(%)/Volt(V) Off-Grid Discharge Cut-Off SOC(%)/Volt(V): When
the inverter connects to the grid and if the battery is discharging to take the load, it will stop discharge
when the SOC is lower than this limit.
Forced Discharge
• Forced Discharge Enable/Disable: If the customer wants to simply discharge the battery; you can
enable forced discharge function, and set both the discharge power and time period.
•
Forced Discharge Power(kW): Forced discharge power limit.
•
Stop Discharge SOC(%)/Volt(V): If Battery SOC is lower than this limit, the inverter will stop forced
discharging function.
•
Forced Discharge Start Time 1-3: Start time for Forced Discharge.
•
Forced Discharge End Time 1-3: End time for Forced Discharge.
To Next Page
Loading...
Need help?
General
