Installation
9
transportation.
When the crucible pos. 20 is not 100% over the balance pedestal, please readjust the
home position (please follow the procedure below)
Pos: 1.3 /0010 ELTRA/0010 opera ting_instructi ons/Thermostep /05 Installati on/0515 Modul Ho me position s ettings @ 14\m od_14537953 23213_9.docx @ 97116 @ @ 1
Home position settings:
1. Start the TGA software
2. Enable the break/pause button
3. Open the furnace
4. Status of the sensors in controller window
To Next Page
Loading...
