Express Install for File OE release 7.0 or lower
209
NAS Install Options
EMC CONFIDENTIAL
e. Enter the domain and hostname for the Control Station. Optionally, enter
secondary and tertiary nameserver IP addresses. Tab to Ok and press Enter.
Figure 120 Example of Configure Network window
11. After setting up the enclosures, the system reports the number of Data Movers
detected. If the system reports the correct number of Data Movers, enter yes to
confirm, and go to step 13 .
12. If the system does not report the correct number of Data Movers, enter no.
The system returns to the command prompt. Do the following:
a. Verify that the network cables from the Control Station to the Data Movers are
correctly connected and fully seated.
b. Enter the reboot command to try discovering the Data Movers again.
c. If the system still reports the wrong number of Data Movers, contact EMC
Customer Service.
The system displays the following message:
Checking for existing system RG/LUN.
13. The Celerra Install/Upgrades dialog box appears. If the system prompts you to
choose the system configuration (Figure 121), select Gateway and press Enter.
Figure 121 System configuration settings
A confirmation prompt appears.
To Next Page
Loading...
Need help?
General
