EMC VNX VG2 User Manual

EMC VNX VG2/VG8 Gateway Configuration Setup Guide
210
NAS Install Options
EMC CONFIDENTIAL
14. To confirm the Gateway selection, tab to Ok and press Enter.
The system prompts you for the backend type (Figure 122).
Figure 122 Backend settings
15. Select CLARiiON or Symmetrix and press Enter.
A confirmation prompt appears.
16. Tab to Ok and press Enter to confirm the type of backend for the gateway.
17. If prompted (Figure 123):
a. Enter the values for the IP addresses of SP A and SP B in the designated fields.
Obtain these values from the “VNX boot array worksheet” on page 276.
b. If security is initialized on the backend, enter the administrator login and
password for the VNX array. Otherwise, leave these fields blank.
c. Tab to Ok and press Enter. The system will now verify the IP addresses.
Note: This prompt is not displayed for gateway systems that are using a Symmetrix
backend for the boot array.
Figure 123 VNX SP settings

EMC VNX VG2 Specifications

General

Brand	EMC
Model	VNX VG2
Category	Gateway
Language	English