EMC VPLEX with GeoSynchrony 4.1 Installation and Setup Guide
10
Warnings and Cautions
WARNING
This product operates at high voltages. To protect against physical harm, power off
the system whenever possible while servicing.
WARNING
In case of fire or other emergency, isolate the system's power involved and alert
appropriate personnel.
CAUTION
Trained personnel are advised to exercise great care at all times when working on
the EMC hardware.
Remember to:
◆ Remove rings, watches, or other jewelry and neckties before you begin any
procedures.
◆ Use caution near any moving part and any part that may start unexpectedly
such as fans, motors, solenoids, etc.
◆ Always use the correct tools for the job.
◆ Always use the correct replacement parts.
◆ Keep all paperwork, including incident reports, up to date, complete, and
accurate.
Static precautions EMC incorporates state-of-the-art technology in its designs, including the use of LSI
and VLSI components. These chips are very susceptible to damage caused by static
discharge and need to be handled accordingly.
CAUTION
Before handling printed circuit boards or other parts containing LSI and/or VLSI
components, observe the following precautions:
◆ Store all printed circuit boards in antistatic bags.
◆ Use a ground strap whenever you handle a printed circuit board.
◆ Unless specifically designed for nondisruptive replacement, never plug or
unplug printed circuit boards with the power on. Severe component damage
may result.
To Next Page
Loading...
Need help?
General
