EMC VPLEX

EMC VPLEX with GeoSynchrony 4.1 Installation and Setup Guide
34
Setting up VPLEX
9. Open a Command Prompt window (Start > Programs > Accessories > Command
Prompt), and type the following command to confirm the settings:
ipconfig
Output example:
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix . : eng.emc.com
IP Address............:128.221.252.3
Subnet Mask...........:255.255.255.224
Default Gateway.........:128.221.252.2
10. Type the following command to verify that you can reach the management
server’s service port:
ping 128.221.252.2
11. On your laptop, launch PuTTY.exe.
Note: If you see a PuTTY security alert, read it, and then click yes.
12. Configure the PuTTY Configuration window as shown in Figure 21.
Figure 21 PuTTY settings for VPLEX_service session
13. Select SSH in the Category list, and ensure that Preferred SSH protocol version
is set to 2, as shown in Figure 22.
PuTTY
Type:
128.221.252.2
(default)
(default)
Type session name:
VPLEX_service