Setting up a VPLEX Local implementation
35
Setting up VPLEX
Figure 22 PuTTY configuration: SSH protocol
14. For most of the setup tasks, you can leave your laptop connected directly to the
management server, or you can move to a more-comfortable location and
reconnect to the management server over the customer network:
• If you are going to move your connection (as described later), go to step 15.
• If you are going to remain connected directly for the entire setup procedure,
read the following information, and then perform any desired steps:
– The output from some commands you will type is too long to read in a
standard-size PuTTY session window. One solution is to extend the
scrolling capability. To do this, select Window in the Category list, and set
Lines of scrollback (shown in Figure 23)to20000.
Figure 23 PuTTY configuration: Scrollback setting
SSH protocol
version
putty_ssh
scrollback
Set to 20000
To Next Page
Loading...
Need help?
General
