Operation
Liebert
®
SRC
™
User Manual 96
8.5.9 Setting the Temperature
You can adjust the temperature simply by pressing .
8.5.10 Adjusting Air Flow
1. Press to cycle through the fan-speed options (displayed in Fan Speed section).
2. Press to cycle through the wind-direction options (displayed in Air-flow/Louvers section).
8.5.11 Selecting Energy-saving Cooling
Energy-saving cooling operation improves comfort and power-saving capacity by automatically adjusting
temperature during cooling mode.
1. Press until is displayed in the sub-function section of the display.
2. Press .
The setting is saved.
3. Press to exit the sub-function set-up.
8.5.12 Selecting Automatic Drying
Automatic drying dries the inside of the indoor unit when it is turned-off by operating the fan to remove
moisture and prevent mold.
1. Press until is displayed in the sub-function section of the display.
2. Press .
The setting is saved.
3. Press to exit the sub-function set-up.
NOTE
In Auto mode, both setpoints adjust automatically when you set the
temperature in this way.
To adjust the cooling or heating setpoint individually, press the appropriate
button before adjusting the temperature.
NOTE
Energy-save mode can only be set up in Cooling mode and does not operate
with Auto Mode.
To Next Page
Loading...
Need help?
General
