Electrical Connections
Liebert
®
SRC
™
User Manual 82
1. Once the proper location for the thermostat is determined, determine the cable-entry location from one
of three options:
•Back
•Top
• Right
2. If you use top or right-side entry, remove the cable-guide groove from the back plate with long-nose
pliers, Figure 6-15.
Figure 6-15 Cable-entry hole/guide grooves
3. Place the back plate in the installation location and secure it with screw, Figure 6-16.
• Do not bend the back plate when tightening screws.
• If there is an electric box, fit the back plate to the box when installing.
• Do not leave a gap between the wall and back plate or the thermostat could move or shake.
Figure 6-16 Thermostat back plate installation
No. Description
1 Back entry (through wall)
2Top entry
3 Right-side entry
To Next Page
Loading...
