Operation
97 Liebert
®
SRC™ User Manual
8.5.13 Selecting Fan Auto
Operates the fan when the outdoor unit is running.
1. Press until is displayed in the sub-function section of the display.
2. Press .
The setting is saved.
3. Press to exit the sub-function set-up.
8.6 Function Settings
8.6.1 Setting Louver Angle Control
Adjusts the angle of airflow.
1. Press repeatedly until flashes in the Function Settings section of the display.
2. Press to select the vane number, or All to set all vanes at once (STD sets all louvers
to factory-default).
3. Press to select the angle, then press .
4. Repeat Steps 2 and 3 for each louver if needed.
5. When done, Press .
The settings are saved.
6. Press to exit the function set-up.
8.6.2 Locking the Display
Locks the display to prevent un-authorized use.
1. Press repeatedly until flashes in the Function Settings section of the display.
2. Press to select , then press .
The display is locked.
3. Press to exit the function set-up.
NOTE
While louver/vane angle is adjusted, commands from the central controller
are delayed for 1 minute.
To Next Page
Loading...
