Installation
Liebert
®
SRC
™
User Manual 30
3. Move the bottom of the unit toward the installation plate to anchor to wall, Figure 3-15.
• It helps to press the lower-left and -right sides of the unit against the installation plate until the
hooks engage in their slots.
• You will hear a clicking sound as the bottom attaches to the installation plate.
Figure 3-15 Move the bottom of the unit to the plate and attach to plate
4. Finish by inserting 2 type “C” screws into the bottom of the installation plate, Figure 3-16.
• As you insert the screws, pay attention to the position of the piping through any wall, as shown in
the figure.
Figure 3-16 Insert and tighten screws
3.4.5 Prepare for Piping/Electrical Connection
1. To prepare the indoor unit for piping, disengage the bottom on the indoor unit from the installation plate
by reversing Step 3 of 3.4.4 - Mounting the Indoor Unit to the Plate.
• This separates the bottom of the indoor unit from the wall mount so you can route the drain hose
correctly. Figure 3-17 shows the rear view of the indoor unit.
2. Swing the drain-hose holder (L-bracket) out and anchor as show in Figure 3-15.
Installation Plate
Drain Hose
Holder
L-bracket
Type 'C' Screws
Bo om of
Indoor Unit
Indoor Unit
Piping
Thr ough
Wall
To Next Page
Loading...
