Emerson Process Management GmbH & Co. OHG2-20
X-STREAM X2FD
Instruction Manual
HASXMDE-IM-EX
01/2015
Fig. 2-13: Modbus Interface - Ethernet connector
Note!
Take care that the Modbus terminals
(
2-19) are still installed but not connected!
2.5 Installation - Electrical
If fi tted, the optional RJ45 connection is loca-
ted on an electronics board in the card cage
section of the unit (fi g. 2-4.
To install this connection, a cable must be
fed through the cable entry without a con-
nector.
The connector can be wired on when the free
end has been fed into the instrument:
We recommend the VARIOSUB RJ45 QUICK-
ON connector (PHOENIX CONTACT), which
is supplied with the unit and requires no spe-
cial tools. Wiring instructions can be found
in the separate manual supplied with the
connector.
Optional Modbus RJ45 connection
Pin 1 Pin 8
Pin no.
Signal
1 TX+
2 TX-
3 RX+
6 RX-
other not used
To Next Page
Loading...
