Emerson Process Management GmbH & Co. OHG3-14
X-STREAM X2FD
Instruction Manual
HASXMDE-IM-EX
01/2015
If the analyzer is operational and it becomes
clear that the incorrect language has been
set, which is unintelligible to the operator, the
3.8 Selecting the language
The DOWN key changes the language. Pres-
sing ENTER will set this language and the
display is updated accordingly.
If the selected language is not the intended
one, the previous three steps can be repeated
until the intended language is set.
Note!
The fourth press of the ENTER key in this
sequence access the “Language” parameter
line.
3.8 Selecting the language
following sequence of keypresses (starting at
the measurement display) can be used to set
the language.
If the system has been set up accordingly, the
code for access level 1 must be entered at this
point to enable access to the following menu.
Note!
The factory setting for this unit is “no code
required”. For ease of operation, it is recom-
mended to use the factory settings for access
codes while setting up the unit for the fi rst
time. In the following sections, therefore, no
more reference will be made to any need for
entering a code.
To Next Page
Loading...
Need help?
General
