Emerson Unidrive SPM - Options; Figure 3-3 Control Options Available with Unidrive SPM

Safety
Information
Introduction
Product
Information
System
configuration
Mechanical
Installation
Electrical
Installation
Getting
Started
Basic
parameters
Running
the motor
Optimization
SMARTCARD
operation
Onboard
PLC
Advanced
parameters
Tec hnic al
Data
Diagnostics
UL Listing
Information
20 Unidrive SPM User Guide
www.controltechniques.com Issue Number: 3
3.6 Options
Figure 3-3 Control options available with Unidrive SPM
* A SMARTCARD is provided as standard. Only one SMARTCARD can be installed at any one time. For further information, refer to Chapter
11 SMARTCARD operation on page 149.
** Paralleling cable is only supplied with a control slave pod.
Power down the drive before installing / removing the
Solutions Module.
WARNING
CT Comms
cable
Feedback Automation Fieldbus
Keypad
SMARTCARD*
Paralleling
cable**
Master
interface
Slave
interface