Emerson X-STREAM XE - Page 197

Emerson Process Management GmbH & Co. OHG 6-35
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
10/2012
6
Software Menus
Ch2
Tolerances
DeviatToler.: Off
Zero Limit: 20.0 %
Span Limit: 20.0 %
6.2.3 Setup Menu
6.2.3.2.2 Setup Calibration Tolerances
This parameter determines whether the tole-
rance check is active during calibration (On),
or not (Off).
If tolerance check is enabled (On), setup the
limits for zero and span gas individually.
Accepted values: 0 ... 100 %
(of the channel´s full range)
Multi-channel unit:
In SELECT COMPONENT, select the chan-
nel to be congured.
Multi-channel unit:
Press
left to enter SELECT COMPONENT,
to change the settings for another channel.
Setup..
Calibration..
Tolerances..