Emerson X-STREAM XE - Page 376

Emerson Process Management GmbH & Co. OHG8-6
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
10/2012
Message
Status level
Explanation Recommended Actions
SCAL blowback
Function check
Device runs system
calibration’s blowback mode
• Wait until system calibration
procedure is nished
• Cancel system calibration
procedure
SCAL program sequence
Function check
Device runs system
calibration’s program se-
quence
SCAL spanning
Function check
Currently a system
calibration’s spanning is on-
going
SCAL zeroing
Function check
Currently a system
calibration’s zeroing is on-
going
• Wait until system calibration
procedure is nished
• Cancel system calibration
procedure
SCAL zeroing & spanning
Function check
Currently a system calibrati-
on (zeroing and spanning) is
ongoing
Sensor CRC-check
Failure
XPSV - CPU communication
failure
Call Emerson service, if mes-
sage shows up repeatedly
Sensor command buffer
overow
Failure
Sensor failure
Failure
Sensor invalid message
length
Failure
SENSOR RESET
Maintenance
8.2.1 Analyzer Related Messages