PROline Promag 53 9 Troubleshooting
Endress+Hauser 111
9.6 Spare parts
Chap. 9.1 contains a detailed troubleshooting guide. The measuring device, moreover,
provides additional support in the form of continuous self-diagnosis and error mes-
sages.
Fault rectification can entail replacing defective components with tested spare parts.
The illustration below shows the available scope of spare parts.
!
Note:
You can order spare parts directly from your E+H service organization by providing the
serial number printed on the transmitter's nameplate (see Page 9).
Spare parts are shipped as sets consisting of the following parts:
• Spare part
• Additional parts, small items (threaded fasteners, etc.)
• Mounting instructions
• Packaging
Fig. 53: Spare parts for Promag 53 transmitter (field and wall-mount housing)
1 Power unit board (85 - 260 V AC, 20 - 55 V AC, 16 - 62 V DC)
2 Amplifier board
3 I/O board (flexible assignment)
4 Pluggable input/output submodules (ordering structure
→ Page 97)
5 I/O board (permanent assignment)
6 S-DAT™ (sensor data memory)
7 T-DAT™ (transmitter data memory)
8 F-Chip™ (function chip for optional software)
9 Display module
1
2
3
5
4
9
6
7
8
8
F06-53xxxxxx-03-06-06-xx-000
To Next Page
Loading...
