PROline Promag 53 5Operation
Endress+Hauser 65
5.2 Brief operating instruction to the function matrix
!
Note:
• See the general notes on Page 66.
• Function descriptions → see the “Description of Device Functions” manual
1. HOME position → F → Enter the function matrix
2. Select a block (e.g. OUTPUTS)
3. Select a group (e.g. CURRENT OUTPUT 1)
4. Select a function group (e.g. CONFIGURATION)
5. Select a function (e.g. TIME CONSTANT)
Change parameter / enter numerical values:
OS → select or enter enable code, parameters, numerical values
F → save your entries
6. Exit the function matrix:
– Press and hold down Esc key (X) for longer than 3 seconds → HOME position
– Repeatedly press Esc key (X) → return step by step to HOME position
Fig. 44: Selecting functions and configuring parameters (function matrix)
F06-x3xxxxxx-19-xx-xx-xx-000
To Next Page
Loading...
