Endress+Hauser Proline Promass 83 - Resource Block

Commissioning Proline Promass 83 PROFIBUS DP/PA
106 Endress+Hauser
Data structure of the module combinations supported
The modules shown in the table can be integrated in the automation system in conjunction with
the TOTAL module (totalizer value) by means of the following module combinations:
DISPLAY_VALUE module - cyclic transmission of a display value to the local display
Any value (32-bit floating-point number) incl. status can be cyclically transmitted directly to the
local display via the automation system (PROFIBUS master) using the DISPLAY_VALUE module.
Display value assignment to the main line, secondary line or info line can be configured via the local
display itself or a class 2 master (operating program).
Data structure of the DISPLAY_VALUE module:
Status:
The measuring device interprets the status in accordance with PROFIBUS Profile Specification
Version 3.0. The statuses O.K., BAD and UNCERTAIN are indicated on the local display by a
corresponding symbol. → Page 42
SETTOT_TOTAL
Output data: Input data:
Byte 1 Byte 1 Byte 2 Byte 3 Byte 4 Byte 5
SETTOT Totalizer value TOTAL Status
SETTOT_MODETOT_TOTAL
Output data: Input data:
Byte 1 Byte 2 Byte 1 Byte 2 Byte 3 Byte 4 Byte 5
SETTOT MODETOT Totalizer value TOTAL Status
Byte 1 Byte 2 Byte 3 Byte 4 Byte 5
Display value Status