Proline Promass 83 PROFIBUS DP/PA Commissioning
Endress+Hauser 105
The following settings are possible:
!
Note!
In the case of customised settings, the units can deviate from the factory setting.
Example:
You want to cyclically transmit the totalised volume flow as totalizer value 1 to the automation
device by means of the TOTAL module.
Configuration via the local display:
BASIC FUNCTION → PROFIBUS PA → TOTALIZER → SELECT TOTALIZER:
Select TOTALIZER 1, then select CHANNEL = VOLUME FLOW
Configuration via the operating program:
Open totalizer function block 1 and enter the ID for volume flow in the “CHANNEL”
parameter → 273.
SETTOT, MODETOT modules - cyclic configuration of totalizers 1...3
The totalizers 1...3 can be configured and controlled by means of the automation system (class 1
master) using the SETTOT and MODETOT modules.
Data structure of the SETTOT module:
Data structure of the MODETOT module:
Function overview:
Example for SETTOT and MODETOT:
If the SETTOT parameter is set to 1 (= reset the totalizer), the value for the aggregated totals of the
totalizer is reset to 0. If the aggregated totals of the totalizer should constantly retain the value 0,
the MODETOT parameter must first be set to 3 (= totalising is stopped) and then the SETTOT
parameter must be set to 1 (= reset the totalizer).
Measured variable ID for “CHANNEL” parameter
Mass flow 277 (factory setting TOTAL 1...3)
Volume flow 273
Corrected volume flow 398
Byte 1
SETTOT
Byte 1
MODETOT
Function Control variables for totalizer 1...3
SETTOT Control of totalizer.
0 = Totalise (factory setting)
1 = Reset totalizer
2 = Preset totalizer
MODETOT Control of totalizer.
0 = Balance (factory setting)
1 = Only positive flow detection
2 = Only negative flow detection
3 = Totalising is stopped
To Next Page
Loading...
