Commissioning Proline Promass 83 PROFIBUS DP/PA
66 Endress+Hauser
Performing the “Pulsating flow” Quick Setup
This Quick Setup menu guides you systematically through the setup procedure for all the device
functions that have to be parameterised and configured for measuring pulsating flows. Note that this
has no effect on values configured beforehand, such as measuring range, current range or full scale
value.
a0002608-en
Fig. 39: Quick Setup for measuring severely pulsating flows.
Recommended settings are found on the following page.
!
Note!
• The display returns to the cell QUICK SETUP PULSATING FLOW (1003) if you press the ESC
key combination during parameter interrogation.
• You can call up this Setup menu either directly from the “COMMISSIONING” Setup menu or
manually by means of the function QUICK SETUP PULSATING FLOW (1003).
• Only totalizers not yet configured in the current Setup are offered for selection in each cycle.
• The “YES” option remains visible until all the totalizers have been configured.
“NO” is the only option displayed when no further outputs are available.
• Only the outputs not yet configured in the current Setup are offered for selection in each cycle.
• The “YES” option remains visible until all the outputs have been configured.
“NO” is the only option displayed when no further outputs are available.
+
+
E
+
E
3002 3002
3002
4200
4225
8005
6400
6402
6403
6404
4206
4208
4004
4005
B
2002
1003
Esc
E
+
-
XXX.XXX.XX
Yes
Yes
No
No
n
Configure another totalizer ?
o
Current output n Freq.-/Puse output n
Selection of output type
Quit
m
Totalizer 2Totalizer 1
Totalizer 3
Selection totalizer
Quit
Totalizer
mode (DAA)
Totalizer
mode (DAB)
Totalizer
mode (DAC)
Frequency Pulse
Operation mode
Measuring mode
Alarm delay
Assign
LF-Cut off
On-value
LF-Cut off
Off-value
LF-Cut off
Pressure
shock suppression
Quit
Quick Setup
Measuring mode
Time constant
Measuring mode
Time constant
Quick Setup
HOME-POSITION
Display
damping
QS
Plusating Flow
p
Configure another output ?
To Next Page
Loading...
