Enterasys RoamAbout RBT-4102 - Page 109

Radio Interface
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-73
ToviewVAPsettings,usetheshowinterfacewireless<a|g><vap#>command.
RoamAbout 4102#show interface wireless g 1
Wireless Interface Information
===================================================================
----------------Identification-------------------------------------
Description : AP-a-V1
SSID : r&d-a-V1
802.11g band : 802.11g only
Channel : 8 (AUTO)
Status : Enable
----------------Antenna--------------------------------------------
Antenna Select : Fixed
Fixed Antenna Control : Diversity
Antenna ID : 0x0000(Integrated antenna)
Ack-TimeOut : 0 us
----------------802.11 Parameters---------------------------------
Transmit Power : FULL (17 dBm)
Max Station Data Rate : 6Mbps
Multicast Data Rate : 1Mbps
Fragmentation Threshold : 512 bytes
RTS Threshold : 256 bytes
Beacon Interval : 150 TUs
DTIM Interval : 5 beacons
Preamble Length : LONG
Maximum Association : 32 stations
Native VLAN ID : 20
VLAN State : ENABLED
----------------Security-------------------------------------------
Secure Access : ENABLED
Multicast cipher : AES
Unicast cipher : AES
PMKSA Lifetime : 720 minutes
WPA clients : REQUIRED
WPA Key Mgmt Mode : DYNAMIC
WPA PSK Key Type : HEX
Encryption : 64-BIT ENCRYPTION
Default Transmit Key : 1
Common Static Keys : Key 1: ***** Key 2: *****
Key 3: EMPTY Key 4: EMPTY
Pre-Authentication : Disabled
Authentication Type : WPA/WPA2 Mixed
----------------Authentication Parameters--------------------------
802.1X : REQUIRED
Broadcast Key Refresh Rate : 0 min
Session Key Refresh Rate : 0 min
802.1X Session Timeout Value : 60 min
===================================================================